Before You Start

• Open the correct FlexVander equipment and confirm the last action.
• Know which pumps and optional values are included at this installation.
• Know the expected pressure or operating range for the current irrigation task.

Do This

1. Check the overall equipment state and each configured pump state.
2. Compare running feedback with the physical pump.
3. Check operating time or other available pump data when relevant.
4. Check pressure only when the transmitter was commissioned for this pressure line.
5. Check meter or field values only when those sensors are included and commissioned.
6. Look for alarms, missing values, or a state that does not follow the physical equipment.

Verify

• The shown pump state follows the physical pump.
• Pressure changes in the expected direction and remains plausible.
• Included values use the expected name and do not remain stale after a real change.
• No unresolved alarm is hidden by a normal-looking overview.

Technician status commands

Use these commands when Emiko and the physical installation do not show the same result, or when a service record needs the current controller state.

If It Fails

Record the value name, time, shown value, physical reading, pump state, and recent action. Do not change scaling or control limits until wiring and source data are checked.

Next Step