Before You Start

• Confirm the correct equipment, pump, field, and pipe route.
• Confirm safe water supply, valve position, and downstream conditions.
• Check that no person is working on the pump or connected equipment.
• Check the current pump state before sending a new action.

Do This

1. Open the intended FlexVander equipment in Emiko.
2. Select the available start action for the intended pump or pump set.
3. Wait for the normal sequence. Do not repeat the start action while a result is pending.
4. Confirm that the intended physical pump starts and that running feedback appears.
5. When irrigation is complete, use the available stop action.
6. Confirm that all affected pumps stop and feedback returns to the stopped state.

A multi-pump program can start pumps in sequence. The physical layout and configured program decide which pumps are included.

Verify

• The intended pump starts. No unintended pump starts.
• The physical result, feedback, and Emiko state agree.
• The stop action leaves every affected pump in the safe stopped state.

If It Fails

Do not keep repeating the action. Use the installation's safe stop method, then record the action, time, shown state, feedback, and physical result.

Next Step