OnSiteLight Testing

OnSiteLight must be tested to make sure all functions operate as intended.

Procedure:

1. The cabinet must be securely and firmly mounted
2. Any extra holes in the cabinet must be closed or sealed so the cabinet remains watertight
3. All cables must be fixed, and cable glands must be tightened so the glands are watertight
4. Any fuses must be installed, and all electrical switching equipment must be switched on
5. Lamps with DALIDALI (Digital Addressable Lighting Interface) is a standardized digital protocol for lighting control. communication must be configured with addresses
6. Send documentation for the lamp setup to support@vikingegaarden.com with at least:
   1. Fill in the template that can be downloaded here with addresses and outputs per lamp. Note that a lamp can have multiple addresses if DALIDALI (Digital Addressable Lighting Interface) is a standardized digital protocol for lighting control. is used.
   2. Serial number of the VikMoteController with built-in GSM and data logger. GSMGSM (Global System for Mobile Communications) is a widely used standard for mobile communication and data. unit or the serial number of the cabinet where the lamps are connected
7. Send documentation of the installation to support@vikingegaarden.com with at least:
   1. Name of the place where the installation has been carried out, typically the name used in daily operation
   2. Serial number of the VikMoteController with built-in GSM and data logger. GSMGSM (Global System for Mobile Communications) is a widely used standard for mobile communication and data. unit or the cabinet serial number, for example a photo of the nameplate or similar
   3. Overview photo showing the cabinet and installations
   4. Close-up photo showing that the cabinet has been mounted
   5. Any photos of connected equipmentEquipment such as a ServicePedestal or WaterStation., for example lamps and motion detector
8. Perform the SATSite Acceptance Test. testExamples of VikMote SMS commands for changing, adding, listing, and deleting access codes. until it is completed successfully