ServicePedestal Operation

ServicePedestal operation and operating status.

ServicePedestal can be operated with different access media and control boxes.
ServicePedestal indicator lights show operating and fault status.

Restart After Pause

If an outlet is paused, broad local access such as aKey/RFID or phone/voice selection does not automatically start that paused outlet. The user normally starts over by removing and reinserting the plug, and by switching the outlet off and on if a local switch is installed.

If an operator deliberately selects the same outlet in Emiko/App/Web, the equipment can try to start that outlet again while the plug is still inserted, provided normal electrical safety checks pass. No plug means no power.

Indicator Lights

Each electricity outlet has an indicator light showing operating status. For fault status, see ServicePedestal troubleshooting.

Operating Status

Indicator light	Description
Off	The outlet is off or set to pausepauseIf the outlet is set to pause, switch the breaker off and on again before the outlet can be used.
On	The outlet is on.
Slow flashing (0.5 / 0.5 second)	Plug is inserted, breaker is on, and the outlet is ready to be switched on.
Fast flashing (0.1 / 0.1 second)	Waiting for an SMSSMS is a text message that can be sent or received with a mobile phone. reply with the order number, if the function is enabled for the user.
Short flash when attempting to switch on the outlet	Plug is inserted, breaker is on, and the outlet is set to pausepauseIf the outlet is set to pause, switch the breaker off and on again before the outlet can be used.

OrdreManagerModule for registering an order number for a service purchase, such as electricity or water.

OrdreManager is used when the customer needs to enter a requisition numberRequisition number from an ERP system or similar source, used as a reference to the customer order. that is registered together with the purchase of, for example, electricity or water.

Operating principle:

On the equipmentThe controller or product that is being installed, commissioned, operated, or serviced., select the outlets to be activated.
1. For example, select power outlets 1 and 2 on the equipmentThe controller or product that is being installed, commissioned, operated, or serviced..
Call the phone number shown on the equipmentThe controller or product that is being installed, commissioned, operated, or serviced..
When you are approved, the system ends the call and sends an SMSSMS is a text message that can be sent or received with a mobile phone..
Reply to the SMSSMS is a text message that can be sent or received with a mobile phone. with the required requisition numberRequisition number from an ERP system or similar source, used as a reference to the customer order., typically within a few minutes.
1. If the time expires, the previous selection is cancelled and you must start again.
When the system receives the SMSSMS is a text message that can be sent or received with a mobile phone. with the requisition numberRequisition number from an ERP system or similar source, used as a reference to the customer order., it switches on the selected outlets.
The system then links the consumption to the specified requisition numberRequisition number from an ERP system or similar source, used as a reference to the customer order., for example in reports.