VikMote Parameter Guide

You can set parameters by SMS or from Emiko.

When using SMS, include the equipment password unless the sender is already created as a USER or ADMIN.
When using Emiko, send the parameter from the backend. The parameter text does not include the SMS password.

You receive a reply when the equipment accepts an SMS parameter command. See here for test and verification commands.

If You Use SMS

Use your mobile phone to send an SMS to the phone number in the equipment.

The syntax is:

Example that sets 'XXXX' to 17, where 'XXXX' is a command and 17 is a value:

Note:

If the user is created as a VikMote userA VikMote user has limited access and can use ordinary daily functions such as switching an output on or off. or as a VikMote administratorA VikMote administrator has unrestricted access to all functions., the passwordAccess code used for SMS and voice calls, for example in the SMS command '1234 signal'. does not need to be used

Functions:

This is how to add SMS recipients with the command SSYS:

Send the command 1234 SSYS +4588888888 to add the number +4588888888.
Send the command 1234 SSYS +4577777777 to add the number +4577777777.
Send the command 1234 SSYS? to request the current list.
Send the command 1234 SSYS* to delete all numbers.
Send the command 1234 SSYS! +4588888888 to delete only the number +4588888888.

This is how to adjust the equipment name with the command NAME:

Send the command 1234 NAME Valhalla to name the equipment Valhalla.
Send the command 1234 NAME? to request the current equipment name.
Send the command 1234 NAME* to delete the name. The installation should normally always have a name.

This is how to adjust timer number 2 with the command TIMER2:

When a parameter name contains #, replace it with the actual number you want to use in that series.

TIMER# becomes TIMER2 when you want to set timer 2.
OTMIN# becomes OTMIN1 when you want to set the low alarm limit for 1-Wire channel 1.

Use the backend send function in Emiko to adjust parameters in the equipment.

The syntax is:

Functions:

This is how to add SMS recipients with the command SSYS:

This is how to adjust the equipment name with the command NAME:

Send the command NAME Valhalla to name the equipment Valhalla.
Send the command NAME? to request the current equipment name.
Send the command NAME* to delete the name. The installation should normally always have a name.

This is how to adjust timer number 2 with the command TIMER2:

When a parameter name contains #, replace it with the actual number you want to use in that series.

TIMER# becomes TIMER2 when you want to set timer 2.
OTMIN# becomes OTMIN1 when you want to set the low alarm limit for 1-Wire channel 1.

You can combine several parameters in one operation.

The syntax is:

PARAMETER#PARAMETER (where #The # character marks an index number. For example, TIMER# represents a parameter family for multiple inputs, where TIMER1 configures input 1 and TIMER2 configures input 2. separates parameters)

This is how to send several parameters in one SMS:

Send the command 1234 SSYS +4588888888#1234 SSYS +4577777777#1234 NAME Valhalla#1234 TIMER2 27.

This is how to send several parameters from Emiko: