FlexVander Local Operation

Use this route only when SMS, voice, or a local push button was included and tested during commissioning.

Before You Start

Confirm the correct installation and selected pump program.
Confirm approved local phone access before SMS or voice use.
Confirm safe pump, valve, water, and field conditions.
Know the physical stop method before a local start is sent.

Do This

Use only commands supported by the selected pump program. Approved USER and ADMIN phone numbers can use the local SMS or voice route when it is enabled. Emiko access is handled separately.

FlexVander starts one new pump at a time and waits 10 seconds before the next start.
A pump that is already running is not started again.
In Program 2, the submersible pump starts before a requested pressure pump when it is not already running.
The shared Program 2 stop function must be wired to stop every connected pump safely.

Start commands

Command	Function
`T`	Start pressure pump 1. Available in Program 1 and Program 2. Voice key: `1`.

Command	Function
`TT`	Start pressure pump 2. Available in Program 1 and Program 2. Voice key: `2`.

Command	Function
`TX`	Start all pumps enabled by the selected program in the normal sequence. Available in Program 1 and Program 2. Voice key: `4`.

Command	Function
`D`	Start the submersible pump. Available in Program 2 only. Voice key: `3`.

Stop commands

Command	Function
`ST`	Stop pressure pump 1. Available in Program 1 and Program 2. Voice key `5` is available in Program 1.

Command	Function
`STT`	Stop pressure pump 2. Available in Program 1 and Program 2. Voice key `6` is available in Program 1.

Command	Function
`S`	Stop all active or pending pumps through the installed stop function. Available in Program 1 and Program 2. Voice key: `0`.

Local push-button operation

Follow the installed label and model IO page. The wiring, controller platform, and selected program decide which pump actions are available.

FlexVander LX9 eco and LX9 pro

Configure the optional input with FVALOCIN. Use the LX9 eco IO list or LX9 pro IO list before wiring it.

FlexVander AX9 encore and NX-910

Program 1: press briefly to start pressure pump 1, then pressure pump 2. Press for 3 seconds to stop all pumps.
Program 2: press briefly to start the submersible pump, then pressure pump 1, then pressure pump 2. Press for 3 seconds to stop all pumps.

FlexVander LX4 pro and DX4i pro

Program 1: use PUMP 1 or PUMP 2 to start or stop that pressure pump.
Program 2: use SUBMERSIBLE PUMP, PUMP 1, or PUMP 2. Starting a pressure pump also starts the submersible pump.

Select Model Documentation Local Input Setting

Verify

The action is accepted only for the approved user and active program.
The intended physical pump and feedback follow the action.
A stop action leaves all affected pumps in the safe stopped state.

If It Fails

Do not repeat the command while a result is pending. Check local access, signal, selected program, pump feedback, and the physical stop path.

Troubleshooting Access Setup

Next Step

Return to normal Emiko operation after the local task is complete.

Daily Operation Check Status